Set the Number of Properties Per Page for Lists and Taxonomy Pages
Go to Theme Options > General > Lists Layout & Sidebar and set the number of properties per page.
This setting applies to:
- Properties List pages
- Properties List Half pages
- Taxonomy pages
Set the Number of Properties for the Advanced Search Results Page
The number of properties shown on the Advanced Search Results page is controlled separately.
Go to Theme Options > Search > Advanced Search Results Page and set the number of properties to match your preferred page size.
Match the WordPress Reading Setting
You should also use the same value in Settings > Reading > Blog pages show at most.
This value should match the number of properties you want to display per page.
Set the Maximum Number of Pins to Show on the Map
If you see more properties in the list than pins on the map, this is usually caused by the maximum pins limit being lower than the number of properties shown on the page.
For example, if your taxonomy page shows 40 properties, but the map is limited to 25 pins, the list will show all 40 properties while the map will display only 25 pins.
To make the map and the list match, you need to check all settings that control:
- how many properties are shown in the list
- how many pins are allowed to show on the map
Go to Theme Options > Maps > Number of Maps Pins Settings.
Set map pins to at least the number of properties shown on the current page (or higher).
Because pagination offset is applied per page for map queries
For example:
- If your page shows 25 properties, set the map pins limit to 25 or a little higher
- If your taxonomy page shows 40 properties, set the map pins limit to at least 40
If this value is lower than the number of properties in the list, the map will show fewer pins than the list shows properties.
Important
After saving the changes, clear all active cache layers and reload the page.
Example
If an area page has over 40 villas, but the map pin limit is set to 25, the list may show more properties than the map pins.
In this case, increase the map pin limit to at least 40, save the settings, clear cache, and reload the page.